unarchive In The Box of 11.1101 keyboard_arrow_down
- 2 of 01P01336 - Differential Bushing
- 2 of 15.10.335.39 - .875" x .500" x 1.943" Sleeve
- Installation Instructions
add_shopping_cart Suggested Parts 2keyboard_arrow_down
Energy Suspension provides grease to install these parts, but you can never have too much. Grab an extra 3-pack of grease so you can more liberally apply grease when installing.
8 ounce tub of High Performance Grease by Energy
lock Warranty Information keyboard_arrow_down
- Energy Suspension warrants its products against defects in workmanship and material for 7 years or 750,000 miles when used on passenger cars and light trucks. Products that have been abused, altered, or incorrectly installed are not covered. Energy Suspension will replace defective products or component parts, if inspection for factory personnel determines the part to be defective. Warranty replacement covers only the product. Labor claims, time loss, or freight charges will not be honored.
Rear Differential Bushings - Mazda Miata MX5 - 11.1101
With Energy's Hyperflex bushings your swinging rear differential will once again be locked down, increasing your acceleration and removing the chance of further damage to your Miata.
Energy Suspension's 11.1101
Miata Making Noise?
Almost every time you take a corner you swear you can hear clunking coming from the rear end right? Maybe you have a hard time getting your Miata up to speed when the light turns green? These are a couple of the signs that point to failed rear differential bushings. The OE differential bushings installed on your Miata are made of a soft rubber that wears down over time and allows the differential to flex more than it should. When these bushings wear down completely your differential could also begin swinging after you go over bumps or take corners. A swinging differential not only reduces your acceleration and can cause wheel hop, but it could also bang into other chassis parts, causing even more damage!
Lock it Down.
This is Energy Suspension's 11.1101, a Hyperflex polyurethane set of rear differential bushings designed specifically for the 2006 - 2014 Mazda Miata NC. With Energy's Hyperflex bushings your swinging rear differential will once again be locked down, increasing your acceleration and removing the chance of further damage to your Miata. The 11.1101 will also hold up much longer than the old OE rubber, giving you the peace of mind that comes with a dependable ride.
