unarchive In The Box of 11.5114 keyboard_arrow_down
- 2 of 05P06003 - Front Sway Bar Bushings; 21 mm
- 1 of Grease
add_shopping_cart Suggested Parts 3keyboard_arrow_down
Energy Suspension provides grease to install these parts, but you can never have too much. Grab an extra 3-pack of grease so you can more liberally apply grease when installing.
DST Silver Color - Limited Lifetime Warranty
Whiteline Gold Color Plated - 3 Year warranty
lock Warranty Information keyboard_arrow_down
- Energy Suspension warrants its products against defects in workmanship and material for 7 years or 750,000 miles when used on passenger cars and light trucks. Products that have been abused, altered, or incorrectly installed are not covered. Energy Suspension will replace defective products or component parts, if inspection for factory personnel determines the part to be defective. Warranty replacement covers only the product. Labor claims, time loss, or freight charges will not be honored.
Once installed the 11.5114 will make your sway bar perform as if it was an even larger bar! About WordPress Suspension.com
Energy Suspension 11.5114
Missing out with your Miata?
I know you want to take your Mazda Miata NC around those corners as fast as possible, but every time you try it feels like your about to tip over and roll away! This is most likely due to failed OE front sway bar bushings. The OE bushings installed on your Miata are made with a soft rubber that's prone to stretching and cracking. Eventually, these bushings rot away, leaving your sway bar loose and ineffective. Not only does this reduce your handling and cornering ability, but a loose sway bar could bang into other chassis parts, causing even more damage!
Better Than New!
This is Energy Suspension's 11.5114, a set of HyperFlex polyurethane front sway bar bushings designed specifically for your 2006 - 2014 Mazda Miata NC. These HyperFlex polyurethane bushings not only outlast the old OE rubber but once installed they will make your sway bar perform as if it was an even larger bar! Now the 11.5114 is made to fit a 21mm front sway bar, here at DST we make sure to inform everyone that it's crucial to measure your sway bar before you buy bushings for it, that way you can be sure you got the correct size. For more information on measuring your sway bar, check out our How-To Video on our universal sway bar bushings page!
...And Saving Money Too!
The 11.5114 was also made to be easy to install and cost-effective! The bushings are made to fit your OE brackets and bolts to save you money on hardware and each bushing is designed with a split on the flat end so that you can just slip the bushing over the bar instead of having to slide it all the way into place. This split also allows you to keep the bar on your Miata during the install, saving you time and effort, and don't worry, once you tighten down the bushings using your OE brackets and bolts the gap will disappear.