Front End Steering Rebuild Kits
Package kits bundle the wearing front end parts for this truck in one order.
This interactive diagram shows the front suspension, steering, driveline and rear suspension of the 2008 Ford F-150 4x4. Hover over or tap any part to see what it does, the signs that it is worn, and the replacement parts we carry that fit your truck, down to the side and position.
We carry parts for it Not stocked yet Hover or tap any part.
The 2004 to 2008 F-150 4x4 uses independent front suspension. A forged aluminum lower arm and a forged steel upper arm hold each knuckle, and a coilover stands on the lower arm. CV axles drive the front wheels from a differential bolted to the frame, with the carrier on the driver side. Steering is a rack and pinion ahead of the differential, and the sway bar runs behind the lower arms. At the rear, a solid axle sits on leaf springs outboard of the frame rails, with the shocks ahead of the axle.
We carry replacement parts for 33 of the 42 components on this diagram, 148 parts in all. See every part for the 2008 Ford F-150 4WD.
Package kits bundle the wearing front end parts for this truck in one order.
Front and rear shock sets for the whole truck.
One kit with the suspension bushings for the whole truck.
A shock, coil spring and top mount already assembled, so no spring compressor is needed.
Every U-joint for the front and rear driveshafts in one package.
Kits that raise the front to level the truck, or lower it.
The upper ball joint is pressed into the forged steel upper arm. Its stud points down into the top of the tall steering knuckle.
Signs of wear: Clunking over bumps, wandering steering, uneven tire wear, or play when the wheel is rocked top to bottom.
Tip: The factory upper joint comes with the arm. Separate press-in joints fit replacement arms only, so check which arm is on the truck.
See all Front Upper Ball Joint parts for the 2008 Ford F-150 4WD
The lower ball joint is pressed into the outer end of the aluminum lower arm and held with a snap ring. Its stud points up into the bottom of the knuckle.
Signs of wear: Clunking over bumps, wandering steering, uneven tire wear, or play when the wheel is rocked top to bottom.
Tip: On 2004 trucks, check that the truck is the new body style and not the 2004 Heritage, which uses different joints.
See all Front Lower Ball Joint parts for the 2008 Ford F-150 4WD
A curved forged steel arm. Its two bushings bolt to the strut tower bracket beside the top of the coilover, and the ball joint sits at its outer end.
Signs of wear: Clunks, a torn ball joint boot, or cracked bushings.
A forged aluminum A-arm. Its front and rear bushings bolt to two crossmembers, the coilover's lower eye bolts into a clevis in the middle, and the ball joint is at the outer end.
Signs of wear: Clunks on bumps or braking, shimmy, or bushings that are cracked or pushed out of their eyes.
Rubber bushings in the two eyes of the upper arm.
Signs of wear: Squeaks, clunks, or cracked rubber at the arm's inner end.
See all Front Control Arm Bushings parts for the 2008 Ford F-150 4WD
Rubber bushings in the front and rear eyes of the lower arm.
Signs of wear: Clunks over bumps, a pull under braking, or torn rubber.
See all Front Control Arm Bushings parts for the 2008 Ford F-150 4WD
The lower arm pivot bolts carry the cams that set caster and camber.
Signs of wear: The truck will not hold an alignment, or a cam bolt is seized.
Tip: After a lift or leveling kit, a cam kit with more range can bring the alignment back.
See all Front End Alignment Kit parts for the 2008 Ford F-150 4WD
A rubber bumper on the coilover's rod, under the top mount, that stops the suspension at full compression.
Signs of wear: A harsh bang over big bumps, or a split bumper.
The front shock carries the coil spring. A long stem with an eye at its bottom bolts into the lower arm, and the top plate's three studs go up through the strut tower.
Signs of wear: Bouncing after bumps, nose dive under braking, or oil on the shock body.
See all Front Shock Absorber parts for the 2008 Ford F-150 4WD
The coil spring sits on the shock between its lower seat and the top mount.
Signs of wear: A front end that sits low or leans, or a broken coil.
Tip: Replacing the spring needs a spring compressor, or a complete coilover assembly.
See all Front Coil Springs parts for the 2008 Ford F-150 4WD
The top plate of the coilover, with three studs into the strut tower and a rubber insulator.
Signs of wear: A clunk at the top of the front corner or a torn insulator.
The rubber seat between the top of the coil spring and the top mount.
Signs of wear: Creaks when turning or over bumps.
The front sway bar runs across behind the lower arms' rear crossmember, held to the frame rails in two bushings. Its ends reach forward to links on the lower arms.
Signs of wear: Body lean in turns.
The bar's two 34 mm bushings, in brackets under the frame rails.
Signs of wear: Clunks or squeaks over bumps.
See all Front Sway Bar Bushings parts for the 2008 Ford F-150 4WD
A bolt-through link from the end of the sway bar down to the rear leg of the lower arm.
Signs of wear: A rattle or clunk over small bumps.
Tip: Links made through 11/28/2004 and from 11/29/2004 differ; the parts listed for your year show which fits.
See all Front Sway Bar Endlinks parts for the 2008 Ford F-150 4WD
The outer end of the tie rod. Its stud goes into the knuckle's steering arm, ahead of the axle.
Signs of wear: Loose steering, toe wear on the tires, or a torn boot.
Tip: Count the turns when unscrewing it, so the alignment stays close until it can be set.
See all Front Outer Tie Rod End parts for the 2008 Ford F-150 4WD
The inner tie rod screws into the end of the rack inside the boot.
Signs of wear: Play in the steering, or a knock when turning the wheel by hand.
Tip: Inner tie rods change on trucks built from 12/2005.
See all Front Inner Tie Rod End parts for the 2008 Ford F-150 4WD
A hydraulic rack and pinion, ahead of the front differential on the front crossmember, with a rubber boot over each inner tie rod.
Signs of wear: Fluid leaks, a torn boot, or free play in the wheel.
See all Steering Rack Bellow parts for the 2008 Ford F-150 4WD
Each CV axle bolts to a flange at the differential with six bolts and drives the hub. The driver and passenger axles are the same part.
Signs of wear: Clicking in turns, a torn boot, or grease thrown around the wheel.
See all CV Joint Parts - Front parts for the 2008 Ford F-150 4WD
The front differential hangs from the frame on three rubber bushed mounts: two at the carrier on the driver side and one on the tube to the passenger side.
Signs of wear: A clunk when shifting into four wheel drive or on throttle, or the differential sitting low.
The U-joint at the front differential end of the front driveshaft.
Signs of wear: Clunks when shifting into four wheel drive, or a vibration in four wheel drive.
The U-joint where the front driveshaft leaves the transfer case.
Signs of wear: A squeak or clunk in four wheel drive.
The U-joint at the front end of the rear driveshaft, behind the transfer case.
Signs of wear: A clunk taking off, or a vibration that grows with speed.
The U-joint behind the center support bearing, where the two halves of the rear driveshaft meet.
Not on every vehicle: Trucks with a two piece rear driveshaft, which the parts catalogs list for this truck.
Signs of wear: A vibration at highway speed or a clunk on take off.
A rubber cushioned bearing on a crossmember that carries the middle of the two piece rear driveshaft.
Not on every vehicle: Trucks with a two piece rear driveshaft.
Signs of wear: A rumble or vibration at speed, or torn rubber.
The U-joint at the rear axle pinion.
Signs of wear: A chirp at low speed, or a clunk on take off.
The leaf springs run outboard of the frame rails, under the axle. The front eye bolts into a hanger and the rear eye hangs from a shackle.
Signs of wear: Sagging, a broken leaf, or the truck sitting low on one side.
The rubber bushing in the spring's front eye.
Signs of wear: Clunks at the rear on take off and braking.
See all Rear Leaf Spring Bushings parts for the 2008 Ford F-150 4WD
The shackle links the spring's rear eye to a bracket on the frame so the spring can change length as it flexes. Its bushing sits in the bracket.
Signs of wear: A clunk at the rear or a squeak over bumps.
See all Rear Leaf Spring Shackles parts for the 2008 Ford F-150 4WD
Two U-bolts on each side go over the axle tube and down past the spring to a plate under it.
Signs of wear: A shifted axle or a clunk on take off.
The rear shocks stand ahead of the axle, outboard of the springs and frame rails, with an eye at each end.
Signs of wear: Bouncing, bottoming out, or oil on the shock body.
See all Rear Shock Absorber parts for the 2008 Ford F-150 4WD
A rubber bumper under the frame rail over the axle.
Signs of wear: A harsh bang over big bumps.
A sealed hub and bearing bolted to the knuckle with four bolts, with the ABS sensor built in. The CV axle's splined end runs through it.
Signs of wear: A hum that changes in turns, play in the wheel, or an ABS light.
Tip: Six and seven stud hubs both exist, and the hub changed during 2005.
See all Front Wheel Bearing and Hub Assembly parts for the 2008 Ford F-150 4WD
A 330 mm vented rotor over the hub studs.
Signs of wear: Pulsing in the pedal or a scored face.
Tip: Order the six or seven lug rotor to match the wheels.
A sliding caliper on a bracket bolted to the knuckle behind the axle.
Signs of wear: A pull to one side, a stuck caliper, or a fluid leak.
See all Front Brake Caliper parts for the 2008 Ford F-150 4WD
Two pads inside the caliper, one either side of the rotor.
Signs of wear: Squealing, grinding, or a long pedal.
A 348 mm vented rotor whose hat is also the parking brake drum.
Signs of wear: Pulsing in the pedal, or a parking brake that won't hold.
A single piston sliding caliper on the axle flange.
Signs of wear: A pull under braking or a seized slide.
See all Rear Brake Caliper parts for the 2008 Ford F-150 4WD
Two pads in each rear caliper.
Signs of wear: Squealing or grinding from the rear.
Tip: The rear pads changed during 2006; the parts listed for your year show which fits.
Two small shoes inside the rear rotor hat, used only by the parking brake.
Signs of wear: The parking brake will not hold the truck.
See all Parking Brake Shoes parts for the 2008 Ford F-150 4WD
The rubber mount between the transmission and its crossmember.
Signs of wear: A clunk when shifting into drive or reverse.
See all Transmission Mount parts for the 2008 Ford F-150 4WD
Rubber cushions between the frame brackets and the cab and bed.
Signs of wear: Clunks from the body, or a cab that moves on the frame.
Lower ball joints, upper control arms, inner and outer tie rod ends and sway bar links are the usual ones. Check them with the wheels off the ground, because a worn joint shows up as play you can feel by hand.
The factory upper ball joint comes with the upper control arm, so most repairs replace the whole arm. Separate press-in upper joints fit some replacement arms only.
No. The front springs are coil springs on the front struts, and the rear springs are leaf springs. The 2004 F-150 Heritage, which is the older body style, is a different truck with different parts.
Yes. Replacing tie rods, ball joints, control arms or struts changes the alignment. Toe is set at the tie rods, and caster and camber at the cam bolts in the lower arm pivots.
The 2004 to 2008 F-150 4x4 and the 2006 to 2008 Lincoln Mark LT 4x4 share this layout. Some parts changed during the run, such as the front hubs and sway bar links in late 2004, the inner tie rods in late 2005 and the rear brake pads in 2006, so the parts shown are the ones listed for the 2007 and 2008 4WD trucks.
Numbered diagrams to print or save for the shop. The numbers match the numbered parts on the interactive diagram.