2002 Mercury Mountaineer 4WD Suspension Diagram

This interactive diagram shows the front suspension, steering, 4WD driveline and independent rear suspension of the 2002 Mercury Mountaineer 4WD. Hover over or tap any part to see what it does, the signs that it is worn, and the replacement parts we carry that fit, down to the side and position.

2002 Mercury Mountaineer 4WD Suspension Diagram (Full Chassis)

FRONT
The whole chassis from above the driver side. The front of the truck is to the left.

2002 Mercury Mountaineer 4WD Front Suspension and Steering Diagram

PASSENGER SIDEDRIVER SIDEFRONT
Front suspension and rack and pinion steering from above the front driver side corner.

2002 Mercury Mountaineer 4WD Rear Suspension Diagram

DRIVER SIDEPASSENGER SIDEREAR
The independent rear suspension from above the rear driver side corner.

We carry parts for it Not stocked yet Hover or tap any part.

The 2002 to 2005 Explorer and Mountaineer four door share this layout: upper and lower control arms at the front with a coilover standing on each lower arm, an aluminum knuckle, rack and pinion steering ahead of the front axle, and a front differential with CV shafts out to the hubs. The rear is independent: a lower control arm, a forged aluminum upper arm with a ball joint, a toe link and a coilover at each corner, with the rear differential on its own crossmembers and CV half shafts out to the knuckles.

We carry replacement parts for 40 of the 48 components on this diagram, 112 parts in all. See every part for the 2002 Mercury Mountaineer 4WD.

Questions about the 2002 Mercury Mountaineer 4WD suspension

What are the most common front end wear items on a 2002 Mountaineer 4x4?

Lower ball joints, outer tie rod ends, front sway bar links and the lower control arm bushings wear first. Check them with the front wheels off the ground: a worn joint shows up as play you can feel when you rock the wheel.

Does the 2002 Mountaineer have coil springs or torsion bars?

Coil springs at all four corners. Each spring sits on its shock as one coilover unit. There are no torsion bars; those belong to the older Explorer Sport and Sport Trac.

Does the 2002 Mountaineer have a solid rear axle?

No. The four door Explorer and Mountaineer from 2002 have independent rear suspension, with the differential bolted to crossmembers and a CV half shaft to each rear wheel. The two door Explorer Sport and the Sport Trac kept the older solid axle.

Are Explorer and Mountaineer suspension parts the same?

Yes for the arms, ball joints, tie rods, hubs, knuckles, rear links and coilovers of the same year. Spring rates and some catalog listings differ, so check the part fits your vehicle.

Which years share this diagram?

The 2002 and 2003 trucks. The 2004 and 2005 trucks use the same arms and rear suspension but different outer tie rod ends and front coilover assemblies. Trucks built before March 4, 2002 also take a different rear toe link stud.

Printable 2002 Mercury Mountaineer 4WD suspension diagrams

Numbered diagrams to print or save for the shop. The numbers match the numbered parts on the interactive diagram.

2002 Mercury Mountaineer 4WD Suspension Diagram (Full Chassis) with numbered parts
2002 Mercury Mountaineer 4WD Suspension Diagram (Full Chassis)
2002 Mercury Mountaineer 4WD Front Suspension and Steering Diagram with numbered parts
2002 Mercury Mountaineer 4WD Front Suspension and Steering Diagram
2002 Mercury Mountaineer 4WD Rear Suspension Diagram with numbered parts
2002 Mercury Mountaineer 4WD Rear Suspension Diagram