moog-es800952 | Front Outer Tie Rod End | Ford Explorer | MOOG-ES800952

  • moog-es800952 Outer Tie Rod End
  • moog-es800952 Outer Tie Rod End

Outer Tie Rod End

Manufacturer: MOOG
Part Number: moog-es800952
Price: $65.50

check_box In Stock check_box Ships Immediately


  • Moog fulfills their warranty through their individual dealers. That means that in order to receive warranty support, you will have to refer back to the original dealer you purchased the part from. Be sure to check the dealer's warranty support before you buy the part to make sure that they will properly support the warranty. If a dealer will only refer you back to the manufacturer in order to receive warranty support, then you may not actually have any warranty at all.

    WARRANTY:

    Moog Premium Steering Components carry a Limited Lifetime Warranty. Moog R-Series Control Arms, Hub Assemblies, and Strut Assemblies carry a 3 Year Warranty.

    Moog warranties their parts to be free of defects in materials and/or workmanship during these timeframes as measured from the date of purchase.

    If a Moog part should fail due to materials or manufacturing defect while under warranty, we will provide a replacement of the part upon return of the defective part.

    Wearable RUBBER parts are not covered under warranty (Dust boots, bushings, bump stops, etc.)

question_answer Ask us a Question

FitmentOuter Tie Rod End moog-es800952 fits these vehicles:

moog-es800952 | Front Outer Tie Rod End | Ford Explorer | MOOG-ES800952

Moog Tie Rods

Connecting the Driver to the Vehicle

Tie rods are a crucial part of your steering system. When you turn your steering wheel the motion travels through the steering rack, through the tie rods, and finally through your steering arm or spindle. Without tie rods, you wouldn't be able to turn your car. This part is also incredibly important to your vehicle's alignment. If you replace your tie rods, make sure to get an alignment done immediately afterward.

Moog Tie Rod Box
Moog Tie Rod

Designed for Strength, Durability, and Longevity

Moog tie rods feature several differences from the OE. One of the more obvious differences is the overall design itself. Whereas many OE tie rods are two-piece assemblies, Moog's tie rods are forged one-piece units. This one-piece design reduces the chance of early wear, increasing the durability of the part as a whole. To protect your tie rod, Moog uses a neoprene-sealed rubber dust boot. This dust boot is resistant to both extreme temperatures and abrasion. The design for this rubber boot includes a small valve to allow for the flushing of old grease and contaminants. In addition to all these other features, Moog crafts their tie rod end using hardened full-ball metal studs. These hardened studs can stand up to much more than the OE, making the tie rod that much more dependable.

question_answer Customer Questions and Answers


Question:
Does this tie rod come pre greased?
Answer:
Yes it does come pre-greased. It is greased to keep corrosion from happening while on the shelf. The tie rod would need to be greased after installation and at every oil change. Not keeping it greased is the number 1 reason that Moog parts fail.

Question:
Can the nuts the come with the outer tie rod ends (part# ES800952) be purchased separately?
Answer:
Moog does not offer any hardware separately.

Question:
How much grease should be added to a brand new tie rod?
Answer:
You pump grease in while watching the dust boot. When it starts to bulge out STOP. If you over grease it it could rupture the dust boot.