add_shopping_cart Suggested Parts 2keyboard_arrow_down
While MOOG greaseable parts come greased from the factory, they should also be greased at the time of installation. After installation, MOOG recommends greasing these parts at each oil change for the best service life.
Out of grease? No problem we've got you covered with this Mystik Multi-Purpose Grease tube refill.
lock Warranty Information keyboard_arrow_down
Moog fulfills their warranty through their individual dealers. That means that in order to receive warranty support, you will have to refer back to the original dealer you purchased the part from. Be sure to check the dealer's warranty support before you buy the part to make sure that they will properly support the warranty. If a dealer will only refer you back to the manufacturer in order to receive warranty support, then you may not actually have any warranty at all.
WARRANTY:
Moog Premium Steering Components carry a Limited Lifetime Warranty. Moog R-Series Control Arms, Hub Assemblies, and Strut Assemblies carry a 3 Year Warranty.
Moog warranties their parts to be free of defects in materials and/or workmanship during these timeframes as measured from the date of purchase.
If a Moog part should fail due to materials or manufacturing defect while under warranty, we will provide a replacement of the part upon return of the defective part.
Wearable RUBBER parts are not covered under warranty (Dust boots, bushings, bump stops, etc.)
Moog Problem Solver Ball Joints
Moog Ball Joints provide long-lasting dependability and performance. Moog ball joints are made with a hardened steel stud ball. These have a full 360-degree range of movement, allowing for consistent stud articulation throughout the life of the part. Grease grooves allow full lubrication between the housing and the ball stud for extended life.
Ball joints are a pivotal part of your vehicle's suspension, so go with the best replacement with Moog's Ball Joints. A ball joint allows your wheels to rotate when you turn the steering wheel. If your ball joint has failed or is failing, your vehicle's ability to turn is severely hindered. Moog's Ball Joints use innovated designs to maximize the performance and durability of your suspension.
Warranty
Not only do MOOG ball joints provide durability, they also provide peace of mind. Moog ball joints are covered by a Lifetime Warranty and, should you ever need it, can be handled directly through our DST Customer Service Team. Take turns confidently with a Moog ball joint.
Product Reviews for moog-k5103 | Front Lower Ball Joint | Buick Apollo | MOOG-K5103
- 5 Star (9)
-
-
- 100%
-
- 4 Star (0)
-
-
- 0%
-
- 3 Star (0)
-
-
- 0%
-
- 2 Star (0)
-
-
- 0%
-
- 1 Star (0)
-
-
- 0%
-
MOOG moog-k5103
starstarstarstarstar" Review 2 Years Later "
Works as expected!
verified_user Verified Buyer - Daniel J Putt - . MOOG moog-k5103 - 5 out of 5starstarstarstarstar" Very good "
I put them in my 68 Chevelle they work great. I only use Moog ball joints.
verified_user Verified Buyer - Gregg Blomquist - . MOOG moog-k5103 - 5 out of 5starstarstarstarstar" Very good "
I put them in my 68 Chevelle they work great. I only use Moog ball joints.
verified_user Verified Buyer - Gregg Blomquist - . MOOG moog-k5103 - 5 out of 5starstarstarstarstar" Review 2 Years Later "
Holding up fine \nAlthough this is not a car which gets driven daily\n
verified_user Verified Buyer - john elliott - . MOOG moog-k5103 - 5 out of 5question_answer Customer Questions and Answers
- Question:
- The size of the ball joint where it enters the lower control arm , is the 2.010 diameter on the inside or the outside of the knurled part?
- Answer:
- 2.310 inches would be the OD of the knurling on the ball joint.
- Question:
- I need the diameter of the ball joint body portion area that presses into the A Frame ?
- Answer:
- moog-k5103 OD of the body of the ball joint is 2.310 inches.
- Question:
- Can you make just the dust boot from part number k5103 available? No one can find it.
- Answer:
- Unfortunately, Moog does not sell just their dust boots from their parts.
- Question:
- What are the dimensions for part K5103?
- Answer:
- Measurements are: OD =2.310 in Height = 3.660 in ID = 2.010 in Length = 3.660 in Stud Taper Per Foot = 0.047in Stud Thread = 0.562-18in
- Question:
- Can I order the dust boots only from part number k5103?
- Answer:
- No, Moog does not sell their dust boots separately from their parts. However, there is a polyurethane replacement option, https://www.suspension.com/universal-dust-boots.asp
- Question:
- What is the stud taper on part number k5103?
- Answer:
- Moog does not show their dimensions for ball joints. Call Moog tech support 800-325-8886.
- Question:
- Can I buy the original moog dust boots for part number k5103?
- Answer:
- No, Moog does not sell their dust boots individually. You would have to do a polyurethane replacement found at https://www.suspension.com/universal-dust-boots.asp