2010 Chevrolet Malibu Suspension Diagram

This interactive diagram shows the front suspension, steering and rear suspension of the 2010 Chevrolet Malibu. Hover over or tap any part to see what it does, the signs that it is worn, and the replacement parts we carry that fit your Malibu, down to the side and position.

2010 Chevrolet Malibu FWD Suspension Diagram (Full Vehicle)

FRONT
Both ends of the vehicle from above. The front is to the left.

2010 Chevrolet Malibu FWD Front Suspension and Steering Diagram

PASSENGER SIDEDRIVER SIDEFRONT
Front struts, lower arms, steering rack and sway bar from above the front of the vehicle.

2010 Chevrolet Malibu FWD Rear Suspension Diagram

DRIVER SIDEPASSENGER SIDEREAR
Rear multi-link suspension from above the rear driver side corner. The rear of the vehicle is toward the lower right.

We carry parts for it Not stocked yet Hover or tap any part.

Kits and packages for your 2010 Chevrolet Malibu

1 kit

Packages

Front End Steering Rebuild Package Kit
Includes
  • 2 × Outer Tie Rod End
  • 2 × Inner Tie Rod End
  • 2 × Front Lower Control Arm (driver and passenger)
$604.34
View package

See every part for the 2010 Chevrolet Malibu

The Malibu uses MacPherson struts at the front, with the coil spring on the strut and an L shaped lower control arm under each corner on a perimeter cradle. The steering rack sits behind the front axle and the front sway bar links run up to the struts. The rear is a multi-link design on an X shaped crossmember: a curved upper arm, a wide lower arm that carries the coil spring and a short lateral link hold each rear knuckle, a flat trailing arm runs forward from the knuckle to a bushing in the body, and a separate shock absorber damps each corner. The diagram shows the model with four wheel disc brakes.

We carry replacement parts for 32 of the 40 components on this diagram, 87 parts in all. See every part for the 2010 Chevrolet Malibu.

Questions about the 2010 Chevrolet Malibu suspension

What are the most common suspension wear items on a 2010 Chevrolet Malibu?

Front sway bar links, front lower control arms and their rear bushings, outer tie rod ends, front strut mounts and the rear trailing arm bushings are the parts most often replaced, followed by struts and rear shocks.

Do Pontiac G6 and Saturn Aura suspension parts fit the Malibu?

Most do. The Malibu shares its lower arms, ball joints, struts, tie rods, hubs, rear arms, trailing arms and rear shocks with the 2005 to 2010 G6 and the 2007 to 2009 Aura. Front sway bar links are longer on the 2010 to 2012 cars, and springs, sway bar bushings and some brake parts differ by trim and year, so check the fit of each part before ordering.

Does the 2010 Malibu have upper control arms at the front?

No. The front uses struts, so the strut itself locates the top of the knuckle. There is one lower control arm per side with the ball joint pressed into it. The rear has an upper arm on each side.

Which front axle fits my 2010 Malibu?

2010 Malibu LT and LTZ sedans take the Moog 10E024L and 10E024R front axles, the ones shown in the diagram. The 2010 LS and Hybrid are listed with the Moog 10S019 axle, so check the fit notes before ordering.

Do I need an alignment after replacing suspension parts?

Yes, after replacing tie rods, struts, control arms or rear arms. Front toe is set at the tie rods, front camber can be corrected with a cam bolt in the strut clevis, and rear camber and toe kits are sold for the rear arms.

Printable 2010 Chevrolet Malibu suspension diagrams

Numbered diagrams to print or save for the shop. The numbers match the numbered parts on the interactive diagram.

2010 Chevrolet Malibu FWD Suspension Diagram (Full Vehicle) with numbered parts
2010 Chevrolet Malibu FWD Suspension Diagram (Full Vehicle)
2010 Chevrolet Malibu FWD Front Suspension and Steering Diagram with numbered parts
2010 Chevrolet Malibu FWD Front Suspension and Steering Diagram
2010 Chevrolet Malibu FWD Rear Suspension Diagram with numbered parts
2010 Chevrolet Malibu FWD Rear Suspension Diagram