2007 Chevrolet Malibu Suspension Diagram

This interactive diagram shows the front suspension, steering and rear suspension of the 2007 Chevrolet Malibu sedan. Hover over or tap any part to see what it does, the signs that it is worn, and the replacement parts we carry that fit your Malibu, down to the side and position.

2007 Chevrolet Malibu FWD Suspension Diagram (Full Vehicle)

FRONT
Both ends of the vehicle from above. The front is to the left.

2007 Chevrolet Malibu FWD Front Suspension and Steering Diagram

PASSENGER SIDEDRIVER SIDEFRONT
Front struts, lower arms, steering rack and sway bar from above the front of the vehicle.

2007 Chevrolet Malibu FWD Rear Suspension Diagram

DRIVER SIDEPASSENGER SIDEREAR
Rear multi-link suspension from above the rear driver side corner. The rear of the vehicle is toward the lower right.

We carry parts for it Not stocked yet Hover or tap any part.

Kits and packages for your 2007 Chevrolet Malibu

1 kit

Packages

Front End Steering Rebuild Package Kit
Includes
  • 2 × Outer Tie Rod End
  • 2 × Inner Tie Rod End
  • 2 × Front Lower Control Arm (driver and passenger)
$604.34
View package

See every part for the 2007 Chevrolet Malibu

The Malibu sedan uses MacPherson struts at the front, with the coil spring on the strut and an L shaped lower control arm under each corner on a perimeter cradle. The steering rack sits behind the front axle and the front sway bar links run up to the struts. The rear is a multi-link design on an X shaped crossmember: a curved upper arm, a wide lower arm that carries the coil spring and a short lateral link hold each rear knuckle, a flat trailing arm runs forward from the knuckle to a bushing in the body, and a separate shock absorber with an eye at each end damps each corner. The diagram shows the sedan with four wheel disc brakes. The Malibu Maxx hatchback is a longer body with its own rear springs and shocks, so check the listing if you have one.

We carry replacement parts for 33 of the 39 components on this diagram, 96 parts in all. See every part for the 2007 Chevrolet Malibu.

Questions about the 2007 Chevrolet Malibu suspension

What are the most common suspension wear items on a 2007 Chevrolet Malibu?

Front sway bar links, front lower control arms and their rear bushings, outer tie rod ends, front strut mounts and the rear trailing arm bushings are the parts most often replaced, followed by struts and rear shocks.

Is the Malibu Maxx the same as the Malibu sedan?

The front end, rear arms, trailing arms, hubs and tie rods are the same parts, but the Maxx has its own rear springs (Moog CC81365), rear shocks (Monroe 5778, with a stem top) and some bar bushings. Parts for both bodies are listed on the Malibu pages, so check the spring and shock before ordering.

Do Pontiac G6, Saturn Aura and 2008 and later Malibu suspension parts fit the Malibu sedan?

Most of the arms, ball joints, struts, tie rods, hubs, rear arms and trailing arms are shared with the 2005 to 2010 G6, the 2007 to 2009 Aura and the 2008 to 2012 Malibu. Springs, shocks, sway bar bushings and some brake parts differ, so check the fit of each part before ordering.

Does the 2007 Malibu have upper control arms at the front?

No. The front uses struts, so the strut itself locates the top of the knuckle. There is one lower control arm per side with the ball joint pressed into it. The rear has an upper arm on each side.

Which front sway bar does my Malibu have?

Most 2004 to 2007 sedans have a 19 mm bar, and the SS has a 22 mm bar. The bushings fit one size only, so measure the bar or check the old bushing before ordering.

Which front brake pads fit my 2007 Malibu?

2007 sedans take Wagner 1160 front pads (2004 to 2006 sedans take Wagner 1028). Cars with 15 inch wheels use a 276 mm rotor and the others a 296 mm rotor, so measure the rotor before ordering.

Does every Malibu have rear disc brakes?

No. Some base sedans have rear drum brakes, and those cars use their own rear trailing arms. Check behind the rear wheel before ordering rear brake parts or trailing arms.

Do I need an alignment after replacing suspension parts?

Yes, after replacing tie rods, struts, control arms or rear arms. Front toe is set at the tie rods, front camber can be corrected with a cam bolt in the strut clevis, and rear camber and toe kits are sold for the rear arms.

Printable 2007 Chevrolet Malibu suspension diagrams

Numbered diagrams to print or save for the shop. The numbers match the numbered parts on the interactive diagram.

2007 Chevrolet Malibu FWD Suspension Diagram (Full Vehicle) with numbered parts
2007 Chevrolet Malibu FWD Suspension Diagram (Full Vehicle)
2007 Chevrolet Malibu FWD Front Suspension and Steering Diagram with numbered parts
2007 Chevrolet Malibu FWD Front Suspension and Steering Diagram
2007 Chevrolet Malibu FWD Rear Suspension Diagram with numbered parts
2007 Chevrolet Malibu FWD Rear Suspension Diagram